Topic Title

We have seen a recent change in our Coordinates / Hints toolbar. After drawing a Site Plan Boundary and modifying the scale from Arch to Eng and the AngleTyp from Bearing to Normal and then going BACK again, the angle info STAYS in bearing mode rather than converting back to decimal. Does anyone know how to fix this?
Chris

Posts: 30
Joined: Wed Feb 16, 2005 4:27 pm

[Mark F. Madura]

Normal is degrees-minutes-seconds [178-52'-36"]
Bearings is bearing method [S 1-7'-24" W]
Dec. Degrees is decimal degrees [178.877]